七麦数据

Ardu-Con is an application that allows you to turn your iPhone into six channels remote control ( R/C ) to access up to 4 relays and 2 servos through your Arduino UNO connected to an Ethernet or Wifi Shield.

The Ardu-Con application perfectly emulates the switches commands and sticks as a true remote control and sends the data through web requests to your local network.

Your iPhone must be connected to the same network via WiFi.

There are no limits to the imagination and possibilities.
You can control robots, vehicles, lamps and many others devices.

Simply access the settings screen and configure the IP address that is connected to your Ethernet Shield, and connect the necessary hardware to be controlled (LEDs , relays, motors and servos).

Also in settings, you can configure the controller mode:
You can set it up to look like a single “Joystick”, a “Bubble Level Controller”, “T-like Sliders” or “Two Parallel Sliders”. In addition, you can configure the behavior of joystick (sliders), as well the bubble sensivity.
This facilitates the control of devices such as cars, helicopters, planes or drones.

Uploading the sketch to your arduino:
The "Source Code" for the Arduino is described in the application itself. It is written in a clear code and with comments to be freely modified and adapted to your needs.

Simply touch the code to select it, then copy to the clipboard and paste into the notepad , send via e-mail , etc. Transfer to the application that will program your Arduino board.

Read the INFO in the application to learn more about the transmission protocol details and how to connect the Arduino and components.

Ardu-Con is an application that allows you to turn your iPhone into six channels remote control ( R/C ) to access up to 4 relays and 2 servos through your Arduino UNO connected to an Ethernet or Wifi Shield.

The Ardu-Con application perfectly emulates the switches commands and sticks as a true remote control and sends the data through web requests to your local network.

Your iPhone must be connected to the same network via WiFi.

There are no limits to the imagination and possibilities.
You can control robots, vehicles, lamps and many others devices.

Simply access the settings screen and configure the IP address that is connected to your Ethernet Shield, and connect the necessary hardware to be controlled (LEDs , relays, motors and servos).

Also in settings, you can configure the controller mode:
You can set it up to look like a single “Joystick”, a “Bubble Level Controller”, “T-like Sliders” or “Two Parallel Sliders”. In addition, you can configure the behavior of joystick (sliders), as well the bubble sensivity.
This facilitates the control of devices such as cars, helicopters, planes or drones.

Uploading the sketch to your arduino:
The "Source Code" for the Arduino is described in the application itself. It is written in a clear code and with comments to be freely modified and adapted to your needs.

Simply touch the code to select it, then copy to the clipboard and paste into the notepad , send via e-mail , etc. Transfer to the application that will program your Arduino board.

Read the INFO in the application to learn more about the transmission protocol details and how to connect the Arduino and components.